Low-Profile 3-Way Faucet

Introducing the 3-way faucet: Cold water, hot water, RO water

This faucet's neck is made of brass and its base is made of zinc alloy. The mechanism is ceramic and the seals are rubber.

3 ways:
- hot water
- cold water
- RO water

The 3 flexible hoses are included with the faucet. One is equipped with a quick-connect fitting for the water produced by your RO system.

Dimensions:


- Total height: 24 cm
- Total height with the mixer handle open: 27 cm
- Clearance beneath the spout: 16cm
- Total width: also 27 cm
- Width of the threaded section beneath the faucet: 3 cm
- Length of this threaded section: 4 cm
- Width of the faucet base: 5cm

3-way faucet installation video

 
Video transcript - Installing your 3-way faucet

Here are all the accessories included with your 3-way faucet.

- The faucet,

- the 3 mounting pieces,

- the base,

- the 3 flexible hoses, one of which has a special fitting for quarter-inch tubing.

Start by taking your faucet and attaching the cold and hot water hoses on one side and the RO water hose on the other.

Then attach the 2 mounting rods, tightening them with a flathead screwdriver and removing the 2 nuts.

Place the support ring over the sink's standard-diameter hole, then position the faucet, making sure all 3 hoses pass through the hole.

Under the sink, position the rubber and metal mounting pieces, passing the mounting rods through the designated holes.

Screw on the nuts and tighten them securely to hold the faucet firmly in place.

Finally, connect the faucet hoses to the cold water, hot water, and RO water lines.

Make sure everything is tightened securely and use Teflon on the standard water supply connections.

And there you go, your faucet is ready to use.